Paralytic brow ptosis repair
(2:40)
If video fails to load, use this link: https://vimeo.com/132966661/.
Transcript
This is Richard Allen at the University of Iowa. This video demonstrates repair of a right paralytic brow ptosis secondary to a 7th nerve palsy. The amount of elevation needed is determined pre-operatively and marked with a marking pen. A 15 blade is then used to make an incision along the marking. The depth of the incision should be through the skin and subcutaneous fat. A monopolar cautery is then used to remove a flap of skin and subcutaneous fat. As this is a paralytic brow ptosis, a deeper dissection can be performed if preferred. The defect can then be closed with deep interrupted 4-0 vicryl sutures. In this case, a medial cut back is performed to address additional medial brow ptosis. Performing this procedure results in a Burrows triangle, which is then removed. Additional 4-0 Vicryl sutures are placed in order to close the deep layer. 5-0 prolene suture can then be used to close the skin. Medially in the area of the cut back, two vertical mattress sutures are used. A running prolene suture can be used to close the remainder of the incision. These sutures will be removed in approximately one week. Prior to tying the running suture, the prolene will be tightened which I believe is important as prolene has some elasticity to it. At the end of the case, the brow appears to be in appropriate position. Antibiotic ointment is then placed over the incision three times a day for a week.
